Handle Bus Pirates already in bit banging mode correctly
Thanks to Johannes Sjölund for reporting that the Bus Pirate init could
not deal with a Bus Pirate which is already in binary Bitbang mode.
This is caused by a combination of the slowness of the Bus Pirate, the
slowness of USB and a fast serial port flush routine which just flushes
the buffer contents and does not wait until data arrival stops.
Make the Bus Pirate init more robust by running the flush command 10
times with 1.5 ms delay in between.
This code development was sponsored by Mattias Mattsson. Thanks! Tested
a few dozen times, should work reliably.
Corresponding to flashrom svn r1178.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Mattias Mattsson <vitplister@gmail.com>
diff --git a/buspirate_spi.c b/buspirate_spi.c
index c56155f..9890d48 100644
--- a/buspirate_spi.c
+++ b/buspirate_spi.c
@@ -22,6 +22,7 @@
#include <string.h>
#include <stdlib.h>
#include <ctype.h>
+#include <unistd.h>
#include "flash.h"
#include "chipdrivers.h"
#include "programmer.h"
@@ -141,6 +142,20 @@
/* Read any response and discard it. */
sp_flush_incoming();
}
+ /* USB is slow. The Bus Pirate is even slower. Apparently the flush
+ * action above is too fast or too early. Some stuff still remains in
+ * the pipe after the flush above, and one additional flush is not
+ * sufficient either. Use a 1.5 ms delay inside the loop to make
+ * mostly sure that at least one USB frame had time to arrive.
+ * Looping only 5 times is not sufficient and causes the
+ * ocassional failure.
+ * Folding the delay into the loop above is not reliable either.
+ */
+ for (i = 0; i < 10; i++) {
+ usleep(1500);
+ /* Read any response and discard it. */
+ sp_flush_incoming();
+ }
/* Enter raw bitbang mode */
buf[0] = 0x00;
ret = buspirate_sendrecv(buf, 1, 5);
@@ -148,6 +163,8 @@
return ret;
if (memcmp(buf, "BBIO", 4)) {
msg_perr("Entering raw bitbang mode failed!\n");
+ msg_pdbg("Got %02x%02x%02x%02x%02x\n",
+ buf[0], buf[1], buf[2], buf[3], buf[4]);
return 1;
}
msg_pdbg("Raw bitbang mode version %c\n", buf[4]);
@@ -159,8 +176,12 @@
/* Enter raw SPI mode */
buf[0] = 0x01;
ret = buspirate_sendrecv(buf, 1, 4);
+ if (ret)
+ return ret;
if (memcmp(buf, "SPI", 3)) {
msg_perr("Entering raw SPI mode failed!\n");
+ msg_pdbg("Got %02x%02x%02x%02x\n",
+ buf[0], buf[1], buf[2], buf[3]);
return 1;
}
msg_pdbg("Raw SPI mode version %c\n", buf[3]);