Add support for Xilinx parallel III (DLC5) programing cable
The rayer_spi driver defaults to the RayeR cable, but selecting other
predefined pin layouts with the type= parameter is possible:
flashrom -p rayer_spi:type=xilinx
Corresponding to flashrom svn r1437.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
diff --git a/flashrom.8 b/flashrom.8
index 1b9bf60..76f25bd 100644
--- a/flashrom.8
+++ b/flashrom.8
@@ -210,8 +210,8 @@
.sp
.BR "* dediprog" " (for SPI flash ROMs attached to a Dediprog SF100)"
.sp
-.BR "* rayer_spi" " (for SPI flash ROMs attached to a RayeR parport \
-based programmer)"
+.BR "* rayer_spi" " (for SPI flash ROMs attached to a RayeR parport "
+or Xilinx DLC5 compatible cable)
.sp
.BR "* nicintel_spi" " (for SPI flash ROMs on Intel Gigabit network cards)"
.sp
@@ -512,8 +512,22 @@
is base I/O port address of the parallel port, which must be a multiple of
four. Make sure to not forget the "0x" prefix for hexadecimal port addresses.
.sp
-More information about the hardware is available at
-.BR http://rayer.ic.cz/elektro/spipgm.htm .
+The default cable type is the RayeR cable. You can use the optional
+.B type
+parameter to specify the cable type with the
+.sp
+.B " flashrom \-p rayer_spi:type=model"
+.sp
+syntax where
+.B model
+can be
+.BR rayer " for the RayeR cable or " xilinx " for the Xilinx Parallel Cable III
+(DLC 5).
+.sp
+More information about the RayeR hardware is available at
+.BR "http://rayer.ic.cz/elektro/spipgm.htm " .
+The schematic of the Xilinx DLC 5 was published at
+.BR "http://www.xilinx.com/itp/xilinx4/data/docs/pac/appendixb.html " .
.TP
.BR "ogp_spi " programmer
The flash ROM chip to access must be specified with the