Unify some probe functions that basically correspond to probe_jedec()
Use the correct reset sequence for 82802AB. Detailed explanation:
The reset sequence before ID reading was correct, so ID always
worked. But the reset sequence after ID reading was a copy-paste
leftover from probe_jedec and didn't have any effect. I dug up
flash_and_burn from the freebios-v1 tree and found out that 82802ab.c
was indeed a copy of jedec.c with lots of experimental unannotated #if 0
and #if 1.
About the wait_82802ab change:
Before the patch, wait_82802ab entered read status mode, switched to ID
mode, then tried an incorrect and unsupported JEDEC command to exit ID
mode. Nobody ever saw that this failed because all subsequent function
calls had the correct reset sequence at the beginning.
With the patch, wait_82802ab enters read status mode, then switches back
to read mode with the official reset command.
Corresponding to flashrom svn r717.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>
diff --git a/w39v080fa.c b/w39v080fa.c
index 96e83a8..580657f 100644
--- a/w39v080fa.c
+++ b/w39v080fa.c
@@ -22,29 +22,10 @@
int probe_winbond_fwhub(struct flashchip *flash)
{
- chipaddr bios = flash->virtual_memory;
- uint8_t id1, id2;
+ int result = probe_jedec(flash);
- /* Product Identification Entry */
- chip_writeb(0xAA, bios + 0x5555);
- chip_writeb(0x55, bios + 0x2AAA);
- chip_writeb(0x90, bios + 0x5555);
- programmer_delay(10);
-
- /* Read product ID */
- id1 = chip_readb(bios);
- id2 = chip_readb(bios + 0x01);
-
- /* Product Identifixation Exit */
- chip_writeb(0xAA, bios + 0x5555);
- chip_writeb(0x55, bios + 0x2AAA);
- chip_writeb(0xF0, bios + 0x5555);
- programmer_delay(10);
-
- printf_debug("%s: id1 0x%x, id2 0x%x\n", __func__, id1, id2);
-
- if (id1 != flash->manufacture_id || id2 != flash->model_id)
- return 0;
+ if (!result)
+ return result;
map_flash_registers(flash);