Unify some probe functions that basically correspond to probe_jedec()
Use the correct reset sequence for 82802AB. Detailed explanation:
The reset sequence before ID reading was correct, so ID always
worked. But the reset sequence after ID reading was a copy-paste
leftover from probe_jedec and didn't have any effect. I dug up
flash_and_burn from the freebios-v1 tree and found out that 82802ab.c
was indeed a copy of jedec.c with lots of experimental unannotated #if 0
and #if 1.
About the wait_82802ab change:
Before the patch, wait_82802ab entered read status mode, switched to ID
mode, then tried an incorrect and unsupported JEDEC command to exit ID
mode. Nobody ever saw that this failed because all subsequent function
calls had the correct reset sequence at the beginning.
With the patch, wait_82802ab enters read status mode, then switches back
to read mode with the official reset command.
Corresponding to flashrom svn r717.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Stefan Reinauer <stepan@coresystems.de>
diff --git a/stm50flw0x0x.c b/stm50flw0x0x.c
index 3a90d6b..8cbafe2 100644
--- a/stm50flw0x0x.c
+++ b/stm50flw0x0x.c
@@ -42,49 +42,10 @@
int probe_stm50flw0x0x(struct flashchip *flash)
{
- chipaddr bios = flash->virtual_memory;
- uint8_t id1, id2;
- uint32_t largeid1, largeid2;
+ int result = probe_jedec(flash);
- /* Issue JEDEC Product ID Entry command */
- chip_writeb(0xAA, bios + 0x5555);
- programmer_delay(10);
- chip_writeb(0x55, bios + 0x2AAA);
- programmer_delay(10);
- chip_writeb(0x90, bios + 0x5555);
- programmer_delay(40);
-
- /* Read product ID */
- id1 = chip_readb(bios);
- id2 = chip_readb(bios + 0x01);
- largeid1 = id1;
- largeid2 = id2;
-
- /* Check if it is a continuation ID, this should be a while loop. */
- if (id1 == 0x7F) {
- largeid1 <<= 8;
- id1 = chip_readb(bios + 0x100);
- largeid1 |= id1;
- }
- if (id2 == 0x7F) {
- largeid2 <<= 8;
- id2 = chip_readb(bios + 0x101);
- largeid2 |= id2;
- }
-
- /* Issue JEDEC Product ID Exit command */
- chip_writeb(0xAA, bios + 0x5555);
- programmer_delay(10);
- chip_writeb(0x55, bios + 0x2AAA);
- programmer_delay(10);
- chip_writeb(0xF0, bios + 0x5555);
- programmer_delay(40);
-
- printf_debug("%s: id1 0x%02x, id2 0x%02x\n", __func__, largeid1,
- largeid2);
-
- if (largeid1 != flash->manufacture_id || largeid2 != flash->model_id)
- return 0;
+ if (!result)
+ return result;
map_flash_registers(flash);