There are various reasons why a SPI command can fail
Among others, I have seen the following problems: - The SPI opcode is
not supported by the controller. ICH-style controllers exhibit this if
SPI config is locked down. - The address in in a prohibited area. This
can happen on ICH for any access (BBAR) and for writes in chipset write
protected areas. - There is no SPI controller.
Introduce separate error codes for unsupported opcode and prohibited
address.
Add the ability to adjust REMS and RES addresses to the minium supported
read address with the help of spi_get_valid_read_addr(). That function
needs to call SPI controller specific functions like reading BBAR on
ICH.
Corresponding to flashrom svn r500.
Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Uwe Hermann <uwe@hermann-uwe.de>
diff --git a/spi.h b/spi.h
index d3d9805..aa80c43 100644
--- a/spi.h
+++ b/spi.h
@@ -105,4 +105,8 @@
#define JEDEC_BYTE_PROGRAM_OUTSIZE 0x05
#define JEDEC_BYTE_PROGRAM_INSIZE 0x00
+/* Error codes */
+#define SPI_INVALID_OPCODE -2
+#define SPI_INVALID_ADDRESS -3
+
#endif /* !__SPI_H__ */