Add new programmer for SPI EEPROMs attached to Intel 82580 NICs
This patch lets you read and write the EEPROM on 82580-based gigabit NIC
cards. So far it has been tested on copper NICs only, but other variants
employing this controller should work too.
It is a nice substitution for the official eeupdate tool.
Speed is quite decent: less than 4 seconds for erases or writes of 32 kB.
Corresponding to flashrom svn r1832.
Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Signed-off-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
Tested-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Acked-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
diff --git a/programmer.h b/programmer.h
index 093240b..3ad553a 100644
--- a/programmer.h
+++ b/programmer.h
@@ -84,6 +84,9 @@
#if CONFIG_NICINTEL_SPI == 1
PROGRAMMER_NICINTEL_SPI,
#endif
+#if CONFIG_NICINTEL_EEPROM == 1
+ PROGRAMMER_NICINTEL_EEPROM,
+#endif
#if CONFIG_OGP_SPI == 1
PROGRAMMER_OGP_SPI,
#endif
@@ -416,6 +419,12 @@
extern const struct dev_entry nics_intel_spi[];
#endif
+/* nicintel_eeprom.c */
+#if CONFIG_NICINTEL_EEPROM == 1
+int nicintel_ee_init(void);
+extern const struct dev_entry nics_intel_ee[];
+#endif
+
/* ogp_spi.c */
#if CONFIG_OGP_SPI == 1
int ogp_spi_init(void);