Add new programmer for SPI EEPROMs attached to Intel 82580 NICs
This patch lets you read and write the EEPROM on 82580-based gigabit NIC
cards. So far it has been tested on copper NICs only, but other variants
employing this controller should work too.
It is a nice substitution for the official eeupdate tool.
Speed is quite decent: less than 4 seconds for erases or writes of 32 kB.
Corresponding to flashrom svn r1832.
Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Signed-off-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
Tested-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>
Acked-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
diff --git a/flashrom.c b/flashrom.c
index 83bc89a..fc8b073 100644
--- a/flashrom.c
+++ b/flashrom.c
@@ -297,6 +297,18 @@
},
#endif
+#if CONFIG_NICINTEL_EEPROM == 1
+ {
+ .name = "nicintel_eeprom",
+ .type = PCI,
+ .devs.dev = nics_intel_ee,
+ .init = nicintel_ee_init,
+ .map_flash_region = fallback_map,
+ .unmap_flash_region = fallback_unmap,
+ .delay = internal_delay,
+ },
+#endif
+
#if CONFIG_OGP_SPI == 1
{
.name = "ogp_spi",