diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt
index e486763..04fd223 100644
--- a/Documentation/serprog-protocol.txt
+++ b/Documentation/serprog-protocol.txt
@@ -83,7 +83,7 @@
 		lower than the one requested. If there is no lower frequency
 		available the lowest possible should be used. The value
 		chosen is sent back in the reply with an ACK.
-	0x15 (S_CMD_S_PIN_STATE):
+	0x15 (S_PIN_STATE):
 		Sets the state of the pin drivers connected to the flash chip. Disabling them allows other
 		devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can
 		remain attached to the flash chip even when the board is running. The user is responsible to
@@ -98,5 +98,3 @@
 		S_CMD_O_DELAY, S_CMD_O_EXEC.
 		In addition, support for these commands is recommended:
 		S_CMD_Q_PGMNAME, S_CMD_Q_BUSTYPE, S_CMD_Q_CHIPSIZE (if parallel).
-
-See also serprog.h.