diff --git a/flashrom.8.tmpl b/flashrom.8.tmpl
index 924a4f9..907bf6c 100644
--- a/flashrom.8.tmpl
+++ b/flashrom.8.tmpl
@@ -432,7 +432,7 @@
 and store it to a medium outside of your computer, like
 a USB drive or a network share. If you needed to run the board enable code
 already for probing, use it for reading too.
-If reading succeeds and the contens of the read file look legit you can try to write the new image.
+If reading succeeds and the contents of the read file look legit you can try to write the new image.
 You should enable the board enable code in any case now, as it
 has been written because it is known that writing/erasing without the board
 enable is going to fail. In any case (success or failure), please report to
@@ -827,7 +827,7 @@
 .sp
 The parameter
 .B gpiolX=[HLC]
-allows use of the GPIOL pins either as generic gpios with a fixed value during flashing or as addtional CS#
+allows use of the GPIOL pins either as generic gpios with a fixed value during flashing or as additional CS#
 signal, where
 .B X
 can be a number between 0 and 3, denoting GPIOL0-GPIOL3 correspondingly. The parameter may be specified