Add a bunch of new/tested stuff and various small changes 25
Tested mainboards:
OK:
- ASRock Fatal1ty 970 Performance and P4i65G
Reported by anonymous email message ID:
932677687262b1300eaf14260999d9262c31@guerrillamail.com
The latter actually had a tested board enable already.
Flash chips:
- Eon EN25Q128 to PREW (+PREW)
Reported by Adrian Graham
- GigaDevice GD25VQ41B to PREW (+PREW)
Reported by David Hendricks
- Winbond W39V040FB to PREW (+EW)
Reported by fjed on IRC
Miscellaneous:
- Change PCI IDs of "MS-6577 (Xenon)" board enable.
The previous IDs contained the on-board display adapter which is
disabled when a dedicated graphics card is installed.
- Add a note to the README how to overcome the clang warning if only a
single programmer is enabled.
- Fix some typo and manpage problems found by lintian
- r1920 introduced some explicit calls to pkg-config instead of $(PKG_CONFIG).
This patch corrects that.
- Make MS-7094 (K8T Neo2-F V2.0) board enable less contestable.
Previous PCI IDs were board-specific but ot the other of devices
that could be disabled by the firmware or that vary among
hardware revions. There are no good alternatives available.
However, since we always have a DMI decoder available now, we can
use non-board-specific devices without taking risks. Thanks to
Uwe Hermann for reporting and testing.
- Some other small changes to clean up whitespace and fix some warnings
from Debian's lintian.
Corresponding to flashrom svn r1951.
Signed-off-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
Acked-by: Stefan Tauner <stefan.tauner@alumni.tuwien.ac.at>
Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
diff --git a/sb600spi.c b/sb600spi.c
index b1a9cd5..6bd5679 100644
--- a/sb600spi.c
+++ b/sb600spi.c
@@ -512,7 +512,7 @@
msg_pinfo("Writes have been disabled for safety reasons because the presence of the IMC\n"
"was detected and it could interfere with accessing flash memory. Flashrom will\n"
"try to disable it temporarily but even then this might not be safe:\n"
- "when it is reenabled and after a reboot it expects to find working code\n"
+ "when it is re-enabled and after a reboot it expects to find working code\n"
"in the flash and it is unpredictable what happens if there is none.\n"
"\n"
"To be safe make sure that there is a working IMC firmware at the right\n"